Section V · Pages 59–70 (12 pages)

Cooling System

From the 1941–1948 Chrysler Shop Manual

Describes three water pump designs: a bushing type on the C-28, C-34 and C-38, a ball-bearing shaft on the C-30, C-33, C-36 and C-37, and twin bearings on the C-39 and C-40. Overhaul steps for each are included. Also covered are the by-pass thermostat (opens at 157–162°F), the cylinder block water distributor tube, the temperature gauge, and draining and flushing with tool C-311. The section closes with MOPAR rust resistor, anti-freeze testing and air-locked heater cores.

Read this section free, starting at page 59

What this section covers

  • Water pump types and overhaul
  • Thermostat operation
  • Water distributor tube replacement
  • Draining and flushing the cooling system
  • Anti-freeze solutions and testing
  • Heater air-lock
Models
C-28/30/33, C-34/36/37, C-38/39/40: Royal, Windsor, Saratoga, New Yorker, Crown Imperial, Town and Country
Publication
D-11298
Pages
304

What’s inside

Servicing methods

  1. CoverFront cover listing the three model groups covered: C28-C30-C33, C34-C36-C37 and C38-C39-C40.pp. 1–1
  2. IFront Axlepp. 2–18
  3. IIRear Axlepp. 19–28
  4. IIIBrakespp. 29–43
  5. IVClutch and Fluid Drivepp. 44–58
  6. VCooling Systempp. 59–70
  7. VIElectrical Systempp. 71–101
  8. VIIEnginepp. 102–123
  9. VIIIFuel Systempp. 124–143
  10. IXFrame, Springs and Shock Absorberspp. 144–157
  11. XSteeringpp. 158–163
  12. XITransmission (Standard Type)pp. 164–173
  13. XIVacamatic Transmission and Overdrivepp. 174–210
  14. XIHydraulically Operated Transmissionpp. 211–231
  15. XIIUniversal Joints and Propeller ShaftCovers the cross and yoke universal joints: removal, overhaul, and assembly with balance arrows mated. Also covers the propeller shaft center bearing used on 7-passenger models and on the C-33, C-37 and C-40.pp. 232–235
  16. XIIIWheels and Tirespp. 236–243
  17. XIVBodypp. 244–278
  18. XIVTown and Country Carspp. 279–285
  19. XVLubricationpp. 286–293

Service standards and index

  1. XVIService Standardspp. 294–303
  2. Foreword and Section IndexForeword describing the manual's two parts, model code groups and Miller service tools, with the section index and part number D-11298.pp. 304–304