Section 2 · Pages 87–124 (38 pages)

Group 2: Clutch, Conventional Transmissions and Rear Axle

From the 1958 Ford Thunderbird Shop Manual

Four parts covering the clutch, the 3-speed transmission, the overdrive and the rear axle and drive line. It includes flywheel housing bore and face alignment checks, transmission trouble shooting and overhaul, overdrive solenoid, governor and pawl operation, differential and drive pinion overhaul, rear suspension removal, and U-joint replacement.

Read this section free, starting at page 87

What this section covers

  • Clutch service and flywheel housing alignment
  • 3-speed transmission trouble shooting and overhaul
  • Overdrive operation and overhaul
  • Differential and drive pinion service
  • Rear axle removal
  • Drive line U-joint replacement
Year
1958
Make
Ford
Vehicle
Passenger Cars, Thunderbird
Type
Service Manual
Models
1958 Thunderbird with 352 V-8; conventional, overdrive and Cruise-O-Matic
Pages
360

What’s inside

Service groups

  1. 1-1Group 1, Part 1: Enginepp. 5–47
  2. 1-2Group 1, Part 2: Ignition Systempp. 48–61
  3. 1-3Group 1, Part 3: Fuel Systempp. 62–80
  4. 1-4Group 1, Part 4: Cooling SystemCooling system service including fan belt adjustment and replacement and the water pump. The pump has a sealed bearing integral with the shaft; removal, disassembly, assembly and installation steps are shown with press tools and impeller clearance of 0.030 to 0.040 inch.pp. 81–86
  5. 2Group 2: Clutch, Conventional Transmissions and Rear Axlepp. 87–124
  6. 3Group 3: Cruise-O-Matic Transmissionpp. 125–177
  7. 4Group 4: Chassis Suspension and Underbodypp. 178–197
  8. 5Group 5: Steeringpp. 198–220
  9. 6Group 6: Brakespp. 221–238
  10. 7Group 7: Generating and Starting Systemspp. 239–264
  11. 8Group 8: Lights, Instruments and Accessoriespp. 265–293
  12. 9Group 9: Body Maintenance and Repairpp. 294–303
  13. 10Group 10: Doors, Deck Lid and Front Sheet MetalDoor replacement and alignment, door locks, remote control and handle replacement, striker plate adjustment, deck lid hinge, lock and fit, and the hood with its Bowden wire locks, safety catch and hinge alignment, plus grille and bumper replacement.pp. 304–313
  14. 11Group 11: Interior Trim, Seats and Windowspp. 314–333

Maintenance, tools and specifications

  1. 12Group 12: Maintenance, Lubrication and Special ToolsA maintenance chart of operations by mileage interval, a lubrication chart naming the lubricant for each point, such as pressure gun grease, engine oil S.A.E. 10W and Auto. Trans. Fluid Type A, and a numbered list of special service tools by system.pp. 334–337
  2. 13Group 13: Specificationspp. 338–360

Other manuals for this vehicle