Carburetor Calibration Procedure (On Car)

Step-by-step on-car calibration for Computer Command Control carburetors. It starts with the external gage check of mixture control solenoid travel (2/32 to 4/32 inch), then covers lean mixture screw and rich mixture stop screw adjustment, plug installation, idle air bleed valve and idle mixture needle adjustment using dwell readings, and the start of the throttle position sensor adjustment.

What this section covers

• External gage check of solenoid travel
• Lean mixture screw and rich mixture stop screw
• Idle air bleed valve cover removal and adjustment
• Idle mixture needle plug removal and adjustment
• Dwell meter readings
• Throttle position sensor adjustment