Section 8 · Pages 70–103 (34 pages)
Engine Mechanical
From the 1956 Cadillac Shop Manual
The 90-degree overhead valve V-8 with 4 in. bore and 3-5/8 in. stroke, 365 cu. in., 9.75 to 1 compression and 285 hp (305 hp with dual four-barrel carburetors). Describes the lubricating and crankcase ventilation systems, then cylinder head removal and overhaul, hydraulic valve lifters, oil pan, oil and vacuum pumps, pistons, rings, connecting rods, cylinder bore reconditioning, camshaft and timing chain, crankshaft and main bearings, flywheel, engine mountings and engine removal, with torque tightness, special tools and specifications.
Read this section free, starting at page 70What this section covers
- Engine lubrication and ventilation
- Cylinder heads and valves
- Hydraulic valve lifters
- Pistons, rings and connecting rods
- Camshaft and timing chain
- Crankshaft and main bearings
- Year
- 1956
- Make
- Cadillac
- Vehicle
- Passenger Cars
- Type
- Service Manual
- Models
- Series 62, 60 Special (60S), 75 and 86 Commercial Chassis; Sedan deVille, Eldorado Seville
- Publication
- 1098636
- Pages
- 443
What’s inside
Shop manual
- Title Page and ContentsCover, title page with the 1956 coverage statement and part number, the Cadillac Craftsman Code pledge, and the section contents page with its index tabs.pp. 1–4
- 1General InformationForeword and arrangement of the manual, then model identification: engine serial and unit number locations, the engine unit number chart by series and equipment, body number plate, rear axle ratio identification numbers, Hydra-Matic, compressor, radio and Autronic Eye serial plates, and a table of models with wheelbase, length and starting engine numbers.pp. 5–7
- 3FrameX-type frame description for all series, checking frame dimensions with tram gauges or a plumb bob, checking for twist, front cross member replacement by bolting or welding, body bolt locations by body style, and torque tightness.pp. 8–10
- 4Chassis Suspensionpp. 11–33
- 5Power Steeringpp. 34–59
- 6Rear Axlepp. 60–69
- 8Engine Mechanicalpp. 70–103
- 9Engine Electricalpp. 104–131
- 10AEngine Fuel and Exhaustpp. 132–147
- 10BRochester Carburetorpp. 148–159
- 10CCarter Carburetor (Single and Dual)pp. 160–181
- 11Engine Coolingpp. 182–190
- 12Hydra-Matic Transmissionpp. 191–284
- 13Chassis Electricalpp. 285–296
- 14Bodypp. 297–383
- 15Chassis Sheet Metalpp. 384–389
- 16AAir Conditionerpp. 390–410
- 16BAutomatic Heating Systempp. 411–418
- 16CRadiopp. 419–423
- 16DElectric AntennaMotor-driven antenna with nylon cord mast drive: removal and installation, disassembly and assembly of the mast and housing, cleaning the rod, and curing moisture in the body tube or an antenna that will not raise or lower.pp. 424–426
- 16EAutronic Eyepp. 427–433
- 16FFog LampsBumper-mounted fog lamps with built-in turn signals and the ring switch at the headlamp control, plus the aiming procedure on a screen 25 feet away.pp. 434–434
- IndexAlphabetical subject index giving section page numbers (for example 7-12 or 16-A-9) for every procedure, chart and specification in the manual.pp. 435–443







