Section 0 · Pages 1–10 (10 pages)

Introduction and General Information

From the 1942 Buick Shop Manual

Front matter for the 1942 Buick line: a corrections and additions sheet (damper valve lock-out thermostat for compound carburetion, Carter float needle seats, piston fitting chart, stabilizer shaft size), the foreword, the list of 1942 models and body styles by series and wheelbase (118 to 139 inches), the unit index, New Car, 1000 and 2000 mile inspection forms, the product report procedure, General Motors Institute training, the manufacturer's warranty, and a general information table with dimensions and starting serial and engine numbers for Flint, California and Linden production.

Read this section free, starting at page 1

What this section covers

  • Corrections and additions
  • 1942 models and body styles
  • Unit index
  • New car, 1000 and 2000 mile inspection
  • Manufacturer's warranty
  • Dimensions, serial and engine numbers
Year
1942
Make
Buick
Vehicle
Passenger Cars
Type
Service Manual
Models
Special Series 40-A and 40-B, Super Series 50, Century Series 60, Roadmaster Series 70, Limited Series 90
Publication
BPS-1.27
Pages
350

What’s inside

Shop manual

  1. 0Introduction and General Informationpp. 1–10
  2. 1Bodypp. 11–74
  3. 2Framepp. 75–80
  4. 3Chassis Suspensionpp. 81–90
  5. 4Rear Axlepp. 91–107
  6. 5Brakespp. 108–117
  7. 6Enginepp. 118–140
  8. 6Engine Oiling Systempp. 141–144
  9. 6Engine Cooling Systempp. 145–150
  10. 6Manifolds and Heat Controlpp. 151–154
  11. 6Carburetion, Air Cleaner and Fuel Pumppp. 155–184
  12. 6Clutchpp. 185–195
  13. 6Engine Specificationspp. 196–201
  14. 7Transmission and Universal Jointpp. 202–217
  15. 8Fuel Tank and Exhaust Systempp. 218–221
  16. 9Steeringpp. 222–233
  17. 10Wheels and Tirespp. 234–240
  18. 11Chassis Sheet Metalpp. 241–244
  19. 12Electrical Systempp. 245–311
  20. 12Sonomatic Radio Installation and Servicepp. 312–336
  21. 12Electrical Specificationspp. 337–340
  22. 14AccessoriesA list of 1942 Buick accessories, with installation instructions said to come in each package, and a description of the new under-seat car heater, standard on Series 90, with its fresh air tube, blower and automatic car temperature control valve.pp. 341–342
  23. 15Dimensional Drawingspp. 343–346
  24. 15Tightening SpecificationsTorque wrench readings in foot-pounds for typical engine, chassis, brake, axle and steering bolt applications.pp. 347–347
  25. IndexAlphabetical subject index with section page numbers.pp. 348–350

Other manuals for this vehicle