Section 11 · Pages 252–259 (8 pages)
Group 11: Accessories
From the 1961 Ford and Mercury Truck 850–1100 Series Shop Manual
Part 11-2 covers the heater, with a trouble diagnosis guide for insufficient heat and defrosting, and the radio, covering identification, trouble shooting and suppression equipment. The index also places the windshield wipers and the low air pressure buzzer here.
Read this section free, starting at page 252What this section covers
- Heater trouble diagnosis
- Heater operation and replacement
- Radio identification
- Radio trouble shooting
- Suppression equipment
- Windshield wipers
- Year
- 1961
- Vehicle
- Heavy Duty Trucks, Trucks
- Type
- Service Manual
- Models
- 850–1100 Series F, C, T, H trucks; 401, 477, 534 Super Duty V-8 (no diesel)
- Pages
- 309
What’s inside
Front matter
Service groups
- 1Group 1: Engines and Exhaust Systempp. 9–49
- 2Group 2: Ignition System Maintenancepp. 50–58
- 2Group 2: Distributor and Governorpp. 59–65
- 3Group 3: Fuel System Maintenancepp. 66–75
- 3Group 3: Carburetorspp. 76–93
- 3Group 3: Fuel Pump, Tank and LinesPart 3-3 covers the fuel pump, fuel tank replacement and fuel line replacement.pp. 94–96
- 3Group 3: Fuel System SpecificationsPart 3-4 lists fuel system specifications, including carburetor clearances and fuel pump data.pp. 97–97
- 4Group 4: Cooling System Maintenancepp. 98–106
- 4Group 4: Water PumpPart 4-2 covers water pump removal and installation, and disassembly and assembly, on F-, T-, C- and H-series trucks, including the sealed shaft and bearing and the bleed hole in the housing.pp. 107–108
- 4Group 4: Cooling System SpecificationsPart 4-3 gives the cooling system specifications that close Group 4.pp. 109–109
- 5Group 5: Clutches and Manual Transmissionspp. 110–136
- 5Group 5: Auxiliary Transmissionspp. 137–150
- 5Group 5: Gear Shift Linkage and Specificationspp. 151–157
- 6Group 6: Rear Axles and Drive Linespp. 158–225
- 7Group 7: Front Wheel AlignmentPart 7-1 covers the preliminary front end inspection, wheel alignment inspection, and adjustments to camber, caster and toe-in, including caster wedges and spindle connecting rod clamps.pp. 226–228
- 7Group 7: Front and Rear Suspensionspp. 229–232
- 10Group 10: Starting Systempp. 233–239
- 11Group 11: Lighting System, Horns and Instrumentspp. 240–251
- 11Group 11: Accessoriespp. 252–259
- 11Group 11: Specifications and Wiring DiagramsPart 11-3 has the fuse and circuit breaker chart, bulb chart and wiring diagrams, including the C-850 through C-1100 diagram.pp. 260–262
- 12Group 12: Body Construction and Cab Mechanismpp. 263–275
- 13Group 13: Doors and Door Lockspp. 276–281
- 13Group 13: Windowspp. 282–286
- 13Group 13: Interior Trim and SeatsPart 13-3 covers roof trim panel and instrument panel safety cover replacement, and seat adjustment, track, cover, and back and cushion replacement.pp. 287–289
- 14Group 14: Maintenance and Lubrication Schedulepp. 290–296
- 14Group 14: Maintenance Procedure Guidepp. 297–303
- 14Group 14: Special ToolsPart 14-3 lists special tools by system, including rear axle and suspension, transmission, engine and distributor tools, with tool numbers and suppliers such as Snap-On, Owatonna and Manzel.pp. 304–305
