Section 8-A · Pages 149–155 (7 pages)

Body Wiring

From the 1960 Buick Body Service Manual

Body wiring on a 12 volt system with a 40 amp circuit breaker at the left shroud. Installation drawings for four-door, two-door and convertible bodies show the front and rear harness, and circuit diagrams cover rear harness, tail, stop and back-up lights with checks for short and open circuits.

Read this section free, starting at page 149

What this section covers

  • Wiring installation, four-door, two-door and convertible
  • Front and rear harness connector
  • Rear body wiring circuit diagram
  • Short and open circuits
  • 40 amp circuit breaker
Year
1960
Make
Buick
Vehicle
Passenger Cars
Type
Body Service Manual
Models
LeSabre 4400, Invicta 4600, Electra 4700, Electra 225 4800
Pages
180

What’s inside

Body service manual

  1. 0Introduction and General InformationExplains how the manual is arranged, the Fisher Body number plate and how to read style numbers, with the body styles for LeSabre, Invicta, Electra and Electra 225. Also covers care of paint, chrome, fabric, folding top and leather seats.pp. 3–5
  2. 1-AWindshield Assemblypp. 6–11
  3. 1-BWindshield Wiper Two Speed Assemblypp. 12–26
  4. 1-CWindshield Wiper Single Speed Assemblypp. 27–30
  5. 1-DInstrument Panel Assemblypp. 31–34
  6. 1-EShroud Panel and Ventilating SystemDescribes the body ventilating system with its air intake grille and gives removal and installation of shroud panel and ventilator parts, including side ducts, air outlet doors, side foundation and the windshield lower corner gutter.pp. 35–36
  7. 2-AFront and Rear Doorspp. 37–46
  8. 2-BCenter PillarDescription and servicing of the center pillar trim, which is cemented to the pillar and covered by pinchweld finishing moldings, including the cap sealed with body caulking compound.pp. 47–47
  9. 2-CFront Doorspp. 48–62
  10. 2-DRear Doorspp. 63–77
  11. 3-ARear Quarter Trim and Hardwarepp. 78–87
  12. 3-BRear Quarter Panel SealingSealing procedure for the rear quarter panel, paragraph 3-6, to keep water out of the body.pp. 88–90
  13. 4-ABack Windowpp. 91–97
  14. 4-BRear CompartmentRear compartment lid and hinges with the two torsion rods that counterbalance the lid, the rear compartment lock and lock cylinder, striker adjustment and the rear compartment weatherstrip.pp. 98–100
  15. 4-CEstate Wagon Tail Gatepp. 101–115
  16. 6-AHeadlining AssemblyHeadlining formed to the roof by concealed listing wires, secured with cement, tacks, staples or a pronged retainer. Gives removal and installation steps and the hardware to remove first, using headlining inserting tool J-2772.pp. 116–118
  17. 5Bucket Type Front Seats (Page 5-10 Only)A single stray seat page, 5-10, from Group 5. It covers bucket seat-to-floor pan attachment, driver's seat adjuster, gearnut and jackscrew removal, and the actuator motor of the power seat.pp. 119–119
  18. 6-AHeadlining Assembly (Repeated Pages)A second copy of the Section 6-A headlining pages, repeating the description and the removal and installation of the headlining with listing wires.pp. 120–122
  19. 7-AFolding Top General InformationCare of the convertible top assembly: safety precautions on operating the top, care of the plastic rear window and cleaning of the top material with soap suds or a foaming cleanser.pp. 123–124
  20. 7-BOperation of Folding Toppp. 125–128
  21. 7-CRoof Rail WeatherstripsFront, center and rear weatherstrips along each folding top side roof rail, attached with nuts on integral studs, with the servicing procedure and sealing of the ends.pp. 129–130
  22. 7-DFolding Top AdjustmentsAdjustments of the folding top frame and its fit to the windshield header and body.pp. 131–132
  23. 7-EFolding Top Trim Assemblypp. 133–140
  24. 7-FBack CurtainRemoval and installation of the back curtain assembly and of the back curtain plastic window only, including detaching trim sticks and the top compartment bag.pp. 141–142
  25. 7-GHydro-Lectric Systempp. 143–148
  26. 8-ABody Wiringpp. 149–155
  27. 8-BPower Window Circuits and Trouble Diagnosispp. 156–159
  28. 8-CPower Seat Circuit and Trouble DiagnosisPower seat circuits for the horizontal and six-way seats, with wire color and gauge table and trouble diagnosis of the seat switch block and the front and rear vertical and horizontal motors.pp. 160–162
  29. 9-ABody Parts Lubricated Twice a YearLubrication points serviced twice a year: door hinge hold-open clips, lock strikers, rear compartment lid lock bolt, folding top linkage, jamb switch, torque rods, sunshade rods, lift cylinder piston rods and seat adjuster retainer.pp. 163–165
  30. 9-BBody Parts Lubricated When AccessibleParts to lubricate when reachable: door lock outside handles, door window regulators and cams, rear quarter window cams, door lock parts and the door locking mechanism rod pivots.pp. 166–167
  31. 10Exterior Moldingspp. 168–177

Tools and index

  1. Body ToolsList of special body tools by J-number, including the weatherstrip clip inserter J-5757, clip reformer J-5984, trim nut wrenches and molding clip pliers J-7160.pp. 178–178
  2. Alphabetical IndexAlphabetical index of the manual's procedures with page references, from adjuster and arm rest to window and windshield entries.pp. 179–180

Other manuals for this vehicle