Pages 95–101 (7 pages)
Electrical System
From the 1957 Buick Product Service Bulletins
Trunk light adjustment for run-down batteries, spark plug wire removal, the 1957 Delco-Remy distributor specifications, starter noise, distributor end play, generator lubrication, setting ignition timing, the light switch change, horn ring dead spots, the neutral safety switch, wiring harness faults and Safety-Minder speed warning circuit and troubleshooting.
Read this section free, starting at page 95What this section covers
- Distributor specifications
- Setting ignition timing
- Generator failures
- Neutral safety switch adjustment
- Wiring harness routing
- Safety-Minder troubleshooting
- Year
- 1957
- Make
- Buick
- Vehicle
- Passenger Cars
- Type
- Service Bulletin
- Models
- Special Series 40, Super Series 50, Century Series 60, Roadmaster Series 70
- Publication
- BPS 2.415–2.430
- Pages
- 162
What’s inside
Bulletins by subject
- Title Page and Subject IndexTitle page for BPS 2.415–2.430, abridged edition, ©1958, followed by the 1957 subject index listing every article under its group. The index gives no page numbers.pp. 1–7
- General InformationLift adapters for the 1957 frame, which is about ten inches wider than in 1956, the AFA form change, a revised engine oil viscosity chart, the 1957 model list by series and the general specifications (wheelbase, tread, length and overhangs).pp. 8–9
- Enginepp. 10–24
- Engine Fuel and Exhaustpp. 25–46
- Clutch and Transmissionpp. 47–58
- Rear AxleThe 1957 odometer gear table by axle ratio and tire size, axle shaft lubrication, U-joint alignment, the front propeller shaft rubber ring, Saginaw and Spicer rear shaft grease fixes and the new rear axle oil level.pp. 59–61
- Chassis Suspensionpp. 62–79
- Steeringpp. 80–86
- Brakespp. 87–94
- Electrical Systempp. 95–101
- Accessoriespp. 102–106
- Air Conditioningpp. 107–113
- Bodypp. 114–160
- Tools and MiscellaneousKent-Moore engine stand and adapter for the 1957 V-8, the Gas-Per-Mile gauge, inspection of lifting equipment, the J-6525 axle shaft bearing puller and Tune-Care test specifications for 1953–1957 engines.pp. 161–162







