Section 10 · Pages 333–338 (6 pages)
Chassis Sheet Metal
From the 1961 Pontiac Tempest Chassis and Body Shop Manual
Front end sheet metal alignment and replacement: front fender, hood, hood latch and hinges, bumper, grille and lower panel, hood spring and the front fender cross brace assembly.
Read this section free, starting at page 333What this section covers
- Front fender and hood alignment
- Hood latch adjustment
- Hood hinge and spring replacement
- Grille and lower panel
- Front fender cross brace
- Year
- 1961
- Make
- Pontiac
- Vehicle
- Passenger Cars, Tempest
- Type
- Service Manual
- Models
- 1961 Tempest four-cylinder and V-8, Series 2119 sedan and 2135 station wagon
- Publication
- S-6104 TP
- Pages
- 474
What’s inside
Shop manual
- Title Page and ForewordCover and foreword stating that the manual applies to 1961 Tempest models, excludes air conditioning, and was written before production with a second edition planned. Dated September 1960, form S-6104 TP.pp. 1–2
- 1General InformationVehicle identification plate on the left front hinge pillar and body identification plate on the cowl, with series numbers 2119 sedan and 2135 station wagon. Includes the engine rpm to car speed relation and the general dimension specifications.pp. 3–5
- 2General Lubricationpp. 6–12
- 3Coil Spring Suspensionpp. 13–34
- 3AWheels and Tirespp. 35–41
- 4Rear Axle and Propeller Shaftpp. 42–69
- 5Brakespp. 70–82
- 6Engine Mechanicalpp. 83–153
- 6AEngine Cooling and Lubricationpp. 154–169
- 6BEngine Fuelpp. 170–216
- 6CEngine Tune-uppp. 217–220
- 6DEngine Clutchpp. 221–227
- 7Synchro-Mesh Transmissionpp. 228–247
- 7AAutomatic Transmissionpp. 248–285
- 8Fuel Tank and Exhaustpp. 286–290
- 9Steeringpp. 291–303
- 9APower Steeringpp. 304–332
- 10Chassis Sheet Metalpp. 333–338
- 10ABodypp. 339–400
- 11Electrical and Instrumentspp. 401–463
- 12Accessoriespp. 464–469
- 13IndexAlphabetical index of the manual by subject with section page numbers, from accessories and axle shaft through wheels and windshield wiper.pp. 470–474







